Tag: MPEG-4

Categories
Knowledge Support Support exacqVision Server Categories Products

Trigger Inputs Do Not Work on Panasonic Cameras Running H.264 or MPEG-4 in Internet Mode (Over HTTP)

When a Panasonic camera is configured for Internet mode (over HTTP) when using H.264 or MPEG-4 compression, the camera’s trigger inputs do not work correctly. The triggers are in a normally open state by default, but they do not enter an alarm state when the circuit is closed.

<br>

Trigger-Inputs-Do-Not-Work-on-Panasonic-Cameras-Running-H.264-or-MPEG-4-in-Internet-Mode-Over-HTTP.pdf
Categories
Knowledge Support Support exacqVision Server Categories Products

Can exacqVision Hybrid Systems use MPEG-4 Simple Profile?

Yes. eDVR systems use MPEG-4 Advanced Simple Profile by default, and sDVR systems use H.264 by default. To configure the system, complete the following steps for your system type.

<br>

eDVR Systems

  1. Stop the exacqVision Server in Service Control Manager or by running sudo /etc/init.d/edvrserver stop.
  2. Open c:\windows\XDVAPI.ini in Notepad or run sudo nano /usr/local/xdvapi/etc/XDVAPI.ini.
  3. Add MPEG = 0x2C00 in the [config] section. The default value, if missing, is 0x0C00.
  4. Save and exit.
  5. Restart the exacqVision Server.

<br>

sDVR Systems

  1. Stop the exacqVision Server in Service Control Manager or by running sudo /etc/init.d/edvrserver stop.
  2. Open c:\windows\stretch.conf in Notepad or run sudo nano /etc/stretch.conf.
  3. Find the board in your system and add MPEG4=”1″ to the XML element. The default value, if missing, is 0.
  4. Save and exit.
  5. Restart the exacqVision Server.

<br>

Can-exacqVision-Hybrid-Systems-use-MPEG-4-Simple-Profile.pdf